View and Download AMMCO installation instructions manual online. Disc Rotor Lathe. Lathe pdf manual download. iv • AMMCO Brake Lathes. Safety. Safety Notices and. Decals. For your safety, and the safety of others, read and understand all of the safety notices and . Get AMMCO Disc Rotor Lathe Manual. Get all AMMCO manuals!.
|Published (Last):||26 September 2013|
|PDF File Size:||14.68 Mb|
|ePub File Size:||12.8 Mb|
|Price:||Free* [*Free Regsitration Required]|
Remove all adapters from the arbor after machining a rotor and wipe them clean – especially the inboard adapter. DO NOT throw them into a box.
AMMCO 7000 Hustler Disc Brake Lathe Operation Manual
The witness marks should be carefully aligned when installing the arbor, Fig. Loosen the stud nut, Fig. Turn each tool bit control the outer knurled knobs clockwise until the tool bits just contact the rotor faces. Page 11 Brake Lathes Cross Feed – The cross feed draws the twin tool bits across the face of a brake rotor when the cross feed drive is engaged.
Installation Replace or repair damaged or worn cords immediately soon as it is received. Turn the cross feed handwheel clockwise until the tool bits are near the rotor hub, Fig.
The ammc self-aligning spacer amkco diagonal thrust on the adapters. Keep bystanders out of work area.
AMMCO Disc Rotor Lathe : Manual
The cross also be operated manually using the cross feed handwheel. Your manual failed to upload To print the manual completely, please, download it. Comments to this Manuals Your Name.
Spindle Speed – Release the belt tension by moving the V-belt adjusting lever clockwise, Fig. Reset the collars if necessary. Table of Contents Add to my manuals Add. Clean, repair, remount, or replace as necessary. KEEP these and other materials delivered with the unit in a binder near the machine for ease of reference by supervisors and operators.
Safety Safety Notices and Decals For your safety, and the safety of others, read and understand all of the safety notices and decals included here and on the unit. Enter text from picture: When the cross feed has moved the cutting tools all the way across the face of the rotor, the feed will shut off automatically.
KEEP these and akmco materials delivered.
Tell us about it. Brake Lathes Cross Feed – The cross feed draws the twin tool bits across the face of a brake rotor when the cross feed drive is engaged. KEEP these and other materials deliv ered.
Unplug unit from ammcoo source before servicing or adjusting. Center the twin cutter to the rotor.
Replace or repair damaged or worn cords immediately soon as it is received. Use a face shield and dust mask during dusty operations. Either rough or finish cuts may be taken to resurface a rotor. Also always wear safety glasses or a face shield. Turn the left hand tool bit control until the tool bit contacts the rotor surface and makes a scratch cut no deeper than. Reconditioning Disc Brake Rotors-set-up Fig. Don’t have an account? Choose one of the inner grooves when machining medium duty truck rotors.
Page 15 Brake Lathes The scratch will usually appear as an incomplete circle. Feed Speed – Feed speed refers to the number of thousandths of an inch the cutting tools move across the face of the rotor per revolution of the spindle. Retighten the arbor nut. Now engage the automatic cross amco by moving amkco knob a,mco, Fig.
Examine each ammo and the arbor for nicks, burrs, chips, dirt, and rust. After the brake rotor is mounted on the arbor, install the silencer band. The signed bill of lading is acknowledgement by the carrier of receipt in good condition of shipment covered by our invoice. Don’t see a manual you are looking for?
Turn the cross feed handwheel back about a half turn, start the lathe and move the tool bit in to make a second scratch cut. This is caused by runout or wobble due to rotor condition or by the way the rotor is mounted on the arbor.